Spybots Smart Parts  
  img HOME img MODELS img MISSIONS img PROGRAMMING TUTORIALS img NEWS img LINKS img Contact Us img  
  The Unofficial Resource Centre for Lego Spybotic  
   
img  
   
   

MISSIONS

MISSIONS

 
laser maze
Bank robbers have lured your Spybot to a booby trapped factory. You must escape from the factory to stop the robbers. The problem is that there is only one way out of the factory and the factory floor is criss crossed by a randomly generated laser grid. This laser maze is invisible to the naked eye and will deplete your Spybots energy if it is hit. The good news is that your Spybot can detect these lasers and it will use it's arc lights to direct you.
 
execution
  • Place a desklamp about 3 feet above the ground to represent the exit.
  • Place your Spybot beneath the light source to begin light calibration.
  • Press RUN.
  • When the alert light blinks move the spybot to the start position at the other end of the "factory".
  • Tap the bumper to begin.
  • Use the controller buttons to move your spybot.
  • Your spybot will use it's arc lights to tell you what to do. Below are the light positions and their corresponding actions.
arc light combinations
Move Forward Top Red and Top Green Lights Move Forward
Spin Left 2 red lights Spin Left
Spin Right 2 green lights Spin Right
Move Backward Back red and back green light Move Backward
Don't Move All red and all green lights together Don't move
Run for the door! All red and all green light in sequence Area clear, run for the door
 
 
 
  DESIGN© BILL LANE, 2003.  
DISCLAIMER: All content is provided as is, with no warranty stated or implied regarding the quality or accuracy of any content on or off this site. All trademarks, service marks, and copyrights are property of their respective owners. This site is not sponsored, authorized or sanctioned by the LEGO Group nor representative of their opinions in any way. PRIVACY POLICY