| MISSIONS
|
|
|
| gamma overload |
 |
There is an emergency at
the SMART space propulsion
lab that could have a serious effect on our Space Program.
An accident during a routine systems check has caused
a dangerous Gamma radiation leak from the labs reactor.
If not found and sealed quickly it could lead to very
nasty meltdown.
Your mission is to locate the radiation leaks and seal
them fast. You will use your Spybots
onboard geiger counter to locate the leaks. Once found
create a plasma shield around the leak by releasing concentrated
energy bursts from your Spybot.
Beware over-exposure to the leaks will cause radiation
damage to your Spybot
systems. Energy cells will deplete quickly during this
energy draining mission. Fortunately, you can recharge
at booster points dotted around the reactor area. |
| |
| execution |
- Find a space to use for this mission, it will be
the reactor chamber.
- Place any number of desk lamps at the edges of this
space, these will act as energy boosters.
- Place your Spybot
under any of these lights for light calibration.
- Press RUN.
- The alert light will blink when the spybot
is ready.
- Move the Spybot
to the starting position close to the controller.
Make sure it is facing in towards the space.
- Tap the bumper to start.
- Use the controller buttons to steer your Spybot
around the space.
- The alert light will act as your geiger counter.
It will blink to warn of nearby radiation.
- Spin the Spybot
to locate the source of the leak. The alert light
will flash faster and a warning sound will play louder
to warn you of increased radiation levels.
- When you find the leak press the red controller
button to seal the leak.
- The green arc lights will indicate remaining energy
during the mission. When energy is low recharge your
Spybot at the
booster points (the lights) dotted around the chamber.
- The red arc lights will indicate increasing damage
to your Spybot
systems.
|
| |
|
|
|
